6. Then, replenish the engine oil up to the prescribed
level.
(1) Engine oil filter
3. Changing the transmission fluid,
replacing the hydraulic oil filter, and
cleaning the magnetic filter
WARNING
To avoid personal injury or death:
• Be sure to stop the engine and remove the
starter key before changing the hydraulic-oil-
filter-cartridge.
• Allow the engine to cool down sufficiently
because the transmission oil can be hot and
can burn.
IMPORTANT :
• To prevent serious damage to the hydraulic
system, use only a KUBOTA genuine filter.
1. Remove the drain plugs at the bottom of the
transmission case and drain the transmission oil
completely into the oil pan.
2. After draining, reinstall the drain plugs.
(1) Drain plugs
3. Remove the hydraulic-oil-filter.
4. Wipe off metal filings from the magnetic filter with a
clean rag.
(1) Hydraulic oil filter (2) Magnetic filter (wipe off met-
al filings)
5.
Put a film of clean transmission oil on the rubber
seal of the new hydraulic-oil-filter.
6. Quickly tighten the hydraulic-oil-filter until it contacts
the mounting surface.
7. Then tighten the hydraulic-oil-filter by hand an
additional 1/2 turn only.
8. After the new hydraulic-oil-filter has been replaced,
fill with transmission oil up to the upper line of the
gauge.
9. After running the engine for a few minutes, stop the
engine and check the level of the transmission oil
again. Add the transmission oil to the prescribed
level.
10. Make sure that the transmission fluid does not leak
past the seal on the hydraulic-oil-filter.
Transmission oil capacity
44.0 L
(11.6 U.S.gals.)
(1) Gauge
(2) Oil inlet
(A) Range which transmission
oil level is acceptable within
IMPORTANT :
• Do not operate the tractor immediately after
changing the transmission fluid.
PERIODIC SERVICE SERVICE EVERY 400 HOURS
To Next Page
Loading...
