Fax Operation (Advanced) 3-47
In the relay station...The box (called the ‘F-Code Relay Box’ in this fax)
that will receive the documents must be registered in advance and the
initial transmitting party must be informed of the number (the 4-digit
‘subaddress’ in this fax) of that box. (Refer to Registering New F-Code
Relay Boxes on page 3-42.)
1 Set the documents you want to transmit
2 Use the numeric keys to enter the fax number of a relay station.
3 Press the [Subadd.] key.
4 Press the [On] key.
5 Use the numeric keys to enter the appropriate subaddress.
6 Press the [Password] key.
7 If necessary, use the numeric keys to enter the predetermined F-
Code password.
8 Press the [Close] key.
The message display will return to the same screen as was
displayed in step 2. You can now change any transmission settings
that you want or set the time for the transmission to begin.
Note If, during registration of the F-Code Relay Box, the fax
numbers of all of the final destinations that the received documents
will be transmitted to are entered using one-touch keys, this fax is
capable of automatically transmitting the same documents to up to
300 different final destinations in a single operation.
Note You can also enter the fax number using one-touch keys
that have been designated for F-Code Based Communication
as well. If you do use such a one-touch key, press the Start
key and the transmission operation will begin automatically.
ete SpacePause Subadd. Next des
Subaddress TX
Off
_.
Enter using # key.
On
Ba
Dele
Ready for fax transmission.
Subaddress
Password
Note This subaddress is required during an F-Code Based
Communication in order to designate the box in the destination
party's fax. It can be up to 20 digits in length and can include
any combination of the numerals 0 - 9 and the symbols * and #.
You can use the [] and/or [] keys to move the cursor to a
desired location, and you can clear the entered number by
pressing the [Delete] key.
Note The password can be up to 20 digits in length and can
include any combination of the numerals 0 - 9 and the symbols
* and #.
This password is not required if you agree in advance with the
destination party not to use one.
To Next Page
Loading...
