Fax Operation (Names of Parts / Preparations / Features and Functions of this Fax) 1-5
Preparations
When using the fax functions of this machine for the first time after
purchasing your Fax System, perform the procedures as explained in
Designating the Type of Phone Line Being Used (Line Type setting) (Inch
version only) through Setting the Current Date and Time (Date & Time
setting).
Designating the Type of Phone Line Being Used (Line
Type setting) (Inch version only)
Set the type of phone line here to correspond to the type of telephone
service that you are using. BE SURE the type of phone line you select
here is correct because, if the setting is incorrect, fax communication will
be impossible.
1 Press the System Menu/Counter key. The System Menu / Counter
screen will appear.
2 Press the [FAX Default] key.
3 Make sure that Line Type is highlighted and press the [Change #]
key.
4 Press either the [Tone Line (DTMF)] key or the [Pulse Line (10 PPS)]
key, as appropriate.
5 Press the [Close] key. The message display will return to the same
screen as was displayed in step 3.
6 If you are finished making settings, press the Reset key to return to
the initial mode.
Note If your service representative performs these settings during
set-up of your Fax System, there is no further need for you to
perform these procedures.
Note Prior to operation, check the message display to make sure
that the touch panel is in the initial mode for fax operation. (Refer
to What is the Initial Mode? on page 1-9.)
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode screen.
System Menu
Default
Copy
Default
FAX
Language
Setting
MP Tray
Orig. Size
Register
Default
Machine
Accou
To Next Page
Loading...
