3-58 Fax Operation (Advanced)
4 Press the [Program] key.
5 If you do NOT want to designate a time of day for the operation to
begin, press the [Off] key under Delayed TX and go directly to step
7.
6 Use the numeric keys to enter the desired time of day for the
operation to begin.
7 Press the [Send] key or the [RX Polling] key to choose the type of
transmission.
8 Press the [Next] key.
9 Enter the destination fax number.
10Press the [Finish dest. Set] ([Dest. set]) key.
11Enter a name for the program and the [Next] key. (Maximum 20
characters)
12Check the currently registered information and press the key that
corresponds to any item that you want to modify.
13Press the [OK] key. The message display will return to the same
screen as was displayed in step 3.
If you want to continue registering other program keys, repeat steps
3 through 13. If you are finished registering program keys, press the
Reset key. (P) will be displayed next to the registered speed-dial
key.
Modifying or Deleting Registered Information
Dial type
Group
Register the dial.
33600bpsOne-touch
key
Chain
Program
Ba
Delayed TX/TX type
Off
08:00.
No Restri-
ction
Delayed TX
Enter using # key.
On
Ba
Register the dial.
Program Dial(Send) 0006.
Start Time
Send
RX Po
TX
Note If you want to change the entered time, use the []
and/or [] keys to move the cursor to the desired location.
FREE
Program Dial(Send)
Enter Destination.
Register the dial.
book
Address
Abbrev.
Delete
SpacePause
ABC
ABC
0006.
Dest .1
destinat.
Next
GDE
Note You can enter the fax number using the numeric keys,
abbreviated numbers, one-touch keys or the address book.
Chain dial keys can be used as well.
If you want to enter multiple fax numbers with the numeric
keys, press the [Next destinat.] ([Next dest.]) key after each
fax number.
Note In order to enter characters, refer to Entering Characters
on page 2-13.)
Note If you want to cancel the procedure part way through, press
the Reset key. The touch panel will return to the initial mode
settings.
To Next Page
Loading...
