3-44 Fax Operation (Advanced)
If you selected to send a Transmission Report to the initial
transmitting station, go to the next step. If you selected NOT to send
a report, proceed directly to step 14.
12Enter the fax number of the initial transmitting station.
13Press the [Finish dest. Set] ([Dest. set]) key.
14Check the registered information.
Each item can be modified.
15Press the [OK] key. The message display will return to the same
screen as was displayed in step 4. If you want to continue registering
other F-Code Relay Boxes, repeat steps 4 through 15. Once you are
finished registering F-Code Relay Boxes, press the Reset key.
Modifying or Deleting F-Code Relay Boxes
Perform the following procedure when you want to add or delete final
destinations or change other information registered under any F-Code
Relay Box, as well as when you want to completely delete one of those
boxes.
1 Perform steps 1 through 3 of Registering New F-Code Relay Boxes
on page 3-42.
2 Press the key which displays the subaddress for the F-Code Relay
Box you want to modify or delete.
3 Enter the F-Code password (4-digits) for that F-Code Relay Box.
4 Press the [Confirm] key.
Note You can use the numeric keys, one-touch keys and
Chain dial keys to enter the fax number.
Note In order to modify the contents of or completely delete an F-
Code Relay Box, it is necessary to enter the corresponding F-
Code password during the procedure.
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
Subaddress relay box
Register box
8888.
0715.
3333.
( 4 digits)
Enter password using # key.
Password confirmation Ba
Register box
Subaddress relay box
_.
01.
To Next Page
Loading...
