Various Settings and Registration 6-9
Turning Print Out of Each Report ON/OFF
(Print Report setting)
Six different reports can be printed out for checking such points as
whether a transmission or reception was accomplished correctly or not.
You can also have each of these reports printed out automatically or turn
OFF automatic print out of each report.
Activity Report
Set this report to be printed out upon reaching a predetermined number
of communications in order to check the details of those
communications.
Transmission Report
Set this report to be printed out after each transmission to check whether
the transmission was accomplished correctly or not.
Reception Report
Set this report to be printed out after each reception to check whether
the reception was accomplished correctly or not.
Delayed Communication Report
Set this report to be printed out after each communication that uses the
timer is scheduled to check the information related to that
communication.
Restricted Access Report
Set this report to be printed out whenever Restricted Access is turned
ON in order to check the details, listed by department, of all
communications occurring under Restricted Access.
1 Press the System Menu/Counter key. The System Menu / Counter
screen will appear.
Note Select [Output on condition] and then, it is possible to set
this report to be printed out only under certain condition such as a
communication error and a Broadcast Transmission.
Note Select [Output on condition] and then, it is possible to set
this report to be printed out only under certain condition such as a
communication error, a Polling Reception, an Encryption
Reception and an F-Code Based Confidential Reception.
Note If you want to cancel the procedure part way through, press
the Reset key. The touch panel will return to the initial mode
settings.
To Next Page
Loading...
