6-40 Various Settings and Registration
1 Perform steps 1 through 3 of Registering New Encryption Boxes on
page 6-38.
2 Press the key which displays the box number for the Encryption Box
you want to modify or delete.
3 Enter the Box ID (4-digits) for that Encryption Box.
4 Press the [Confirm] key.
5 If you want to delete the registered Encryption Box, press the
[Delete] key and then go to the next step. If you want to modify the
registered information, press the [Change contents] key and then go
directly to step 7.
> Deleting an Encryption Box
6 Press the [Yes] key. The message display will return to the same
screen as was displayed in step 2. Once you are finished modifying
and/or deleting Encryption Boxes, press the Reset key.
> Modifying registered information
7 The currently registered information will be displayed. Refer to
Registering New Encryption Boxes on page 6-38 in order to modify
that information.
8 Press the [Confirm] key. The message display will return to the same
screen as was displayed in step 2. Once you are finished modifying
and/or deleting Encryption Boxes, press the Reset key.
Performing the Operation at the Transmitting Fax
Encrypted Transmission is accomplished by dialing with a one-touch key
that has been designated in advance for Encrypted Transmission.
1 Register the Encryption Key agreed to in advance with the receiving
party. (Refer to Registering New Encryption Keys on page 6-35.)
Encryption box
Register box
9876.
0352.
( 4 digits)
Enter box id using # key.
Box ID confirmation Ba
Register box
Encryption box
_.
02.
Contents change/del.
Change
contents
Ba
Register box
Encryption box
Delete
02.
0352.
0352.
Box. No.
Box. ID
Note Encrypted Transmission is possible to a single destination,
as well as in combination with a Broadcast Transmission.
F-Code Based Communication is not available for use with
Encrypted Communications.
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
To Next Page
Loading...
