3-16 Fax Operation (Advanced)
Managing Information for a Scheduled
Communication (Editing a Communication in
Memory)
You can modify certain information relating to a scheduled
communication that uses the timer or even cancel the communication
completely. You can also print out a sample image of the corresponding
documents as well as initiate (force-start) the communication without
waiting for the actually scheduled start time.
Printing Out a Sample Image of Waiting Documents
If you want to check the documents that correspond to a specific
transmission that is in memory and waiting for transmission, you can
print out a sample page of those documents.
1 Press the [Application] key. The Application screen will appear.
2 Press the [Reserved TX status] key.
The content of the first schedule communication will be displayed.
3 Use the [T] and/or [S] cursor keys to switch to the communication
that you want.
Note If the scheduled communication begins automatically while
you are in the middle of any editing operation, it will impossible to
continue that procedure.
Note Even if you print out a sample image of the documents, the
transmission will be carried out on schedule.
If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
Place the original & assign destination.
Dest
Ready for fax transmission.
Basic Application
Abbrev.
TXAddress
Register
settingbook
Print Report
RX Polling
TX Polling
Basic Application Register
box input
Sub.conf.
TX status
Reserved
on LCD
TX result
on LCD
RX result
data box
Print encr
box output
Sub.conf.
Print Report
Option screen
Select item.
123456
Reservation status
Reserved communication status.
Doc #:
1/2.
Send
TX No.of pages: 001.22:22.
025.
Start Time:
001.(No.party: )
To Next Page
Loading...
