2-18 Fax Operation (Basic)
12To use this key for F-Code Based Communication, press the [On]
key. The Subaddress/Password Input screen will appear.
13Use the numeric keys to enter the desired subaddress and F-Code
password. (Maximum 20 digits)
14Press the [Close] key twice and then go directly to step 20.
15If you want to designate this key for Encrypted Transmission, press
the [Encryption TX] ([Encryption]) key.
16To use this key for Encrypted Transmission, press the [On] key. The
Key Number/Box Number Input screen will appear.
17Use the numeric keys to enter the 2-digit Key Number (01 - 20) that
corresponds to the Encryption Key you want to use for this one-
touch key.
18Press the [Encryption box #] key and then use the numeric keys to
enter the number of the destination party's Encryption Box.
19Press the [Close] key twice.
20To register this one-touch key with the entered information as is,
press the [OK] key.
The message display will return to the same screen as was
displayed in step 3.
If you want to continue registering other one-touch keys, repeat
steps 3 through 20.
21If you are finished making settings, press the Reset key to return to
the initial mode.
Modifying or Deleting Registered Information
1 Press the [Register] key. The Register screen will appear.
2 Press the [Dial] key.
Subaddress TX
Off
_.
Enter using # key.
On
Ba
Subaddress
Password
Register the dial.
One-Touch Key0001.
Dele
Note To switch between the subaddress and password input
screens, press the [Password] key.
A subaddress is required during F-Code Based
Communication in order to designate the other party's
corresponding F-Code Box.
An F-Code password is used during F-Code Based
Communication. However, you do not have to enter an F-
Code password here if you have determined in advance with
the other party not to use one.
Encryption
Off
00 .
Enter using # key.
On
Ba
Encryption
Key No.
Encryption
box #
0000.
Register the dial.
One-Touch Key0001.
Note If the one-touch key that you want to modify is designated for
F-Code Based Communication, you will NOT be able to change
the designation of that key into one for Encrypted Transmission.
Likewise, if it is designated for Encrypted Transmission, you can
NOT change the designation into one for F-Code Based
Communication.
Place the original & assign destination.
Dest
Ready for fax transmission.
Basic Application
Abbrev.
TXAddress
Register
settingbook
Print Report
To Next Page
Loading...
