4-4 Troubleshooting
No DC Loop
No Dial Tone
The modular cord may not be connected properly to either the telephone
or the line jack (L) on the fax. Either that, or there is a problem with the
telephone line. In this case, contact your telephone company.
______
No Response Dialing was accomplished, but connection to the other party was not
possible. Check with the other party.
______
No encryption key is registered. The destination was dialed using a one-touch key that was designated for
Encrypted Transmission, but the Encrypted Transmission was not
possible because the corresponding Encryption Key is no longer
registered in your fax.
6-35
6-43
Message Procedure Page
To Next Page
Loading...
