2-4 Fax Operation (Basic)
1 Adjust the original width guides to match the width of the
documents you want to transmit.
2 Set the documents face-up on the original table.
Setting the Documents on the Platen
Documents can also be transmitted by lifting open the Document
Processor and setting one document at a time directly on the platen.
Always use the platen when transmitting pages from books and the
like.
1 Set the document face-down and align it properly with the lines
on the original size scales.
2 When transmitting single-sheet documents directly from the
platen, be sure to close the Document Processor.
4 Dialing a destination fax number
Use the numeric keys to enter the destination fax number.
Note If the documents are set properly, the original
placement indicator will be lit green.
DO NOT set more documents than indicated by the paper
volume lines that are located on the inside of the rear
document insert guide. Setting more than the acceptable
number of documents can be the cause of document
jams.
Refer to the Operation Guide for your machine for more
detailed information on the Document Processor.
It is possible to set duplex (2-sided) documents and have
both the front and back sides of those documents
transmitted. (Refer to page 3-3.)
CAUTION Do not leave the document processor open
as there is a danger of personal injury.
Note The destination fax number can be up to 32 digits in
length.
If a mistake is made at any point in entering the fax number,
press the [] or [] cursor key to move the cursor to the
desired position and enter the correct number as desired, or
press the Stop/Clear key and enter the full number once
again from the beginning.
To Next Page
Loading...
