2-10 Fax Operation (Basic)
> Stopping the reception in progress
1 Press the [Status] ([Act status]) key in the bottom right of the
touch panel.
2 Press the [Stop] key and the reception will be canceled.
Memory Reception
When you cannot print out because paper has run out or a paper
jam occurs, the data for all received documents will be temporarily
stored in memory and will then be printed out automatically once
printing is enabled.
When a fax has been received into memory, the FAX lamp will light
and Receive document in memory will appear in the message
display. To print out the documents, set paper or fix the paper jam, as
appropriate to the situation.
2 Printing out the received documents
Received document(s) will be printed out and ejected face-down in
the top tray.
No. of pages 001.
Service center
IMPORTANT If, for any reason, power to the fax is disconnected
or lost, data received into memory may be lost. Ask the other party
to retransmit any documents for which data was lost.
Note Refer to the Operation Guide for your machine about the
maximum number of sheets that can be stored. When the
maximum number of sheets has been reached, remove all of
the documents from the top tray.
Even if you cannot print out because paper has run out or a
paper jam occurs, reception is still possible (Memory
Reception).
32 MB of optional memory must be installed in order to use
the Ultra fine resolution.
To Next Page
Loading...
