Fax Operation (Advanced) 3-27
3 Press the [TX Polling] key.
If you are entering documents for this Polling Transmission for the
first time, go to the next step.
If you want to add documents to those which have already been
saved into memory or replace them completely, go directly to step 6.
> Entering documents for the first time
4 If you want to limit who can request transmission of the documents
from your fax, use the numeric keys to enter a 4-digit Polling ID (the
self-station ID of the receiving fax).
5 Press the [Confirm] key and then go directly to step 8.
> Adding or replacing documents
6 If you want simply to add documents to those already in memory,
press the [Add] key. If you want to delete all of the documents
currently in memory and replace them with new documents, press
the [Overwrite] key.
7 Press the [Confirm] key.
If you selected [Overwrite], the message display will return to the
same screen as was displayed in step 4.
8 Select any related transmission settings that you want to use.
9 Press the Start key. The documents will be scanned and stored in
memory where they will awaiting the polling request.
RX Polling
TX Polling
Basic Application Register
box input
Sub.conf.
TX status
Reserved
on LCD
TX result
on LCD
RX result
data box
Print encr
box output
Sub.conf.
Print Report
Option screen
Select item.
Enter using # key.
Polling ID Ba
TX Polling.
( 4 digits)00 00 .
Note If you DO NOT want to designate any specific fax, do not
enter a Polling ID here.
If a Polling ID other than ‘0000’ is entered, the receiving fax
must be one of our models that has the corresponding
capabilities.
Even if you enter ‘0000’, a check of Permit Fax Numbers,
Permit IDs and Rejection Fax Numbers will be performed.
Add orig./overwrite
Add
Overwrite
Ba
TX Polling.
Note If you are using duplex (2-sided) documents, press the
[Duplex TX] key. Refer to Sending 2-Sided Documents
(Duplex Transmission) on page 3-3 for setting procedures.
To Next Page
Loading...
