Kyocera KM-3050

2GN/2GP/2GR-2
1-4-9
Optional
finisher
89
Jam in centerfold unit
(3000-sheet document
finisher only)
The centerfold paper entry sensor (CPES) does not turn
off within specified time of centerfold paper detection sen-
sor (CPDS) turning on.
1770 ms (30 ppm)/
1370 ms (40/50 ppm)
The centerfold paper entry sensor (CPES) does not turn
on within specified time of centerfold paper detection sen-
sor (CPDS) turning on.
1770 ms (30 ppm)/
1370 ms (40/50 ppm)
The centerfold paper entry sensor (CPES) is not turned
off within specified time of its turning on.
2989 ms (30 ppm)/
2313 ms (40/50 ppm)
The centerfold eject switch (CESW) is not turned on
within specified time.
3040 ms
The centerfold eject switch (CESW) is not turned off
within specified time of its turning on.
4213 ms
Centerfold side registration sensor 1 (CSRS1) is not
turned on within specified time.
600 ms
Centerfold side registration sensor 2 (CSRS2) is not
turned on within specified time.
600 ms
89
Jam in centerfold unit
(3000-sheet document
finisher only)
The home position is not detected within the specified
time after driving the centerfold staple motor (CSTM).
1000 ms
The centerfold paper detection sensor (CPDS) is not
turned off within specified time.
4528 ms (30 ppm)/
3504 ms (40/50 ppm)
The centerfold paper detection sensor (CPDS) is not
turned on within specified time.
4528 ms (30 ppm)/
3504 ms (40/50 ppm)
The centerfold paper detection sensor (CPDS) is not
turned off within specified time of its turning on.
2989 ms (30 ppm)/
2313 ms (40/50 ppm)
90
Jam in mailbox
(3000-sheet document
finisher only)
The mail paper entry switch (MPESW) is not turned on
within specified time.
1315 ms (30 ppm)/
1017 ms (40/50 ppm)
The mail paper entry switch (MPESW) is not turned off
within specified time of its turning on.
2989 ms (30 ppm)/
2313 ms (40/50 ppm)
The tray eject sensor (TEJS) does not turn on within
specified time of mail paper entry switch (MPESW) turn-
ing on.
Tray 1 to 4
2618 ms (30 ppm)/
2026 ms (40/50 ppm)
Tray 5 to 7
1483 ms (30 ppm)/
1148 ms (40/50 ppm)
The tray eject sensor (TEJS) is not turned off within spec-
ified time of its turning on.
2989 ms (30 ppm)/
2313 ms (40/50 ppm)
91
Finisher cover open
(3000-sheet document finisher)
The front cover, top cover or right sub tray is opened
when starting the finisher operation.
The centerfold unit top cover is opened when starting the
centerfold operation.
The mailbox cover is opened when starting the operation.
-
(Document finisher)
The finisher cover becomes open during paper is run-
ning.
Paper is remaining in paths at power on.
-
92
Exit sensor non-arrival
jam (document finisher
only)
In the straight mode, the exit sensor (EXS) is not turned
on even if a specified time has elapsed after the paper
entry sensor (PES) was turned on.
1770 ms
Section Description Conditions Specified time