Kyocera TASKalfa 181 - Page 113

Printing Functions
OPERATION GUIDE 5-13
5
2 Press U or V to select Network, and then press
the Enter key.
3 Press U or V to select TCP/IP, and then press the
Enter key.
4 Press U or V to select On, and then press the
Enter key.
DHCP
This machine supports DHCP (Dynamic Host Configuration Protocol). When using DHCP, turn DHCP On.
1 Display the TCP/IP screen referring to steps 1 to 5
of TCP/IP setting.
2 Press U or V to select Change #, and then press
the Enter key.
3 Press U or V to select DHCP, and then press the
Enter key.
4 Press U or V to select On, and then press the
Enter key.
IP Address
Register the IP address of this machine.
NOTE: The IP address that should be registered here differs depending upon your network environment.
Check with your network administrator before performing this setting.
If you use the following procedure to manually register the IP address, be sure to turn the DHCP setting Off
and the TCP/IP setting On.
1 Display the TCP/IP screen referring to steps 1 to 3
of TCP/IP setting.
Back
USB
Interface
Network
Back
NetWare
Network Setting
TCP/IP
Back
On
TCP/IP
Off
On
Off
TCP/IP
Change #
Back
DHCP
TCP/IP Setting
IP Address
Back
On
DHCP
Off