Troubleshooting
OPERATION GUIDE 9-9
9
Print overrun Press
GO.
Printing has not been
performed properly
because of insufficient
memory.
Press the Print key to display the
following messages.
GO: Continues printing.
CANCEL: Cancels printing.
RESET: Resets the printer board. In
this case, only the printer functions
will be reset.
Press U or V to select the desired
processing, and then press the Enter
key.
NOTE: If the auto continue setting
has been turned On, printing will be
automatically resumed after a preset
period of time.
After this error message is displayed,
the page protect mode will be
automatically turned On.
—
RAM disk error
Press GO
An error has occurred in
writing to or reading from
the RAM disk.
Press the Print key, select GO, and
then press the Enter key. The error
will be cleared.
—
Ready to Copy
Toner low.
Toner remaining in the
machine is low.
Prepare the toner container. —
Remove paper from
Finisher. Press GO
There are already 250
sheets of paper stored in
the optional finisher during
printing.
Remove the paper.
Press the Print key. Press U or V to
select GO, and then press the Enter
key. Printing will resume.
NOTE: To cancel printing, select
CANCEL, and then press the Enter
key.
—
Remove paper from
Finisher.
Press START key.
There are already 250
sheets of paper stored in
the optional finisher during
copying.
Remove the paper. —
Error Message Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
