Troubleshooting
9-10 OPERATION GUIDE
Remove paper from
Top tray. Press GO
The output tray capacity is
exceeded during printing.
There are already 250
sheets of paper stored in
the output tray.
There are already 150
sheets of paper stored in
the output tray when the
optional job separator is
installed.
There are already 100
sheets of paper stored in
the output tray when the
optional finisher is
installed.
Remove the paper.
Press the Print key. Press U or V to
select GO, and then press the Enter
key. Printing will resume.
Note
To cancel printing, select CANCEL,
and then press the Enter key.
—
Remove paper from
Top tray.
Press START key.
The output tray capacity is
exceeded during copying.
There are already 250
sheets of paper stored in
the output tray.
There are already 150
sheets of paper stored in
the output tray when the
optional job separator is
installed.
There are already 100
sheets of paper stored in
the output tray when the
optional finisher is
installed.
Remove the paper. —
Replace Waste Toner
Box
The waste toner box is full. Replace the waste toner box with a
new one.
8-9
Reposition
original or
change cassette.
[Reposition
original or
select other paper
cassette.]
The orientations of the
original and the selected
paper are different.
Change the orientation of the original.
If you press the Start key without
changing the orientation, copying will
be performed at a 100 % (1:1)
magnification ratio.
—
Reset all original
in DP.
Remove the originals from the
optional document processor, return
all the originals into the original table,
and restart copying.
9-20
Set cassette.
[Close paper
cassette.]
The cassette is not closed
securely.
First pull it out and push it all the way
back in.
—
Error Message Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
