Safety information Flowmaster User’s and Service Manual | LBL-000990 [B] 79
Please be careful while unpacking the Flowmaster
measurement system. The system consists of delicate
equipment.
Safety can be violated if one of the Flowmaster modules
shows visible damage.
Do not attempt to open one of the Flowmaster modules.
Do not place any equipment in front of the mains plug, to
isolate the system the mains plug must remain easy
accessible.
When installing the Flowmaster, first install the Laborie
software and then plug-in the Bluetooth dongle.
All external devices, supplementary equipment, and
peripherals that you connect to the Flowstar system must
meet the safety standards defined by IEC/EN 60601-1.
This applies to all data input/output ports (e.g., USB,
HDMI, serial).
Make sure the flowsensor is connected to the correct
power supply (F3BT-PS). Do not use a power supply other
than which is specified. Doing so may cause fire leading to
serious accidents.
Do not bend the power cable forcibly, or place a heavy
object on the cable because it might damage the cable
and cause fire or electric shock. If the power cable is
damaged, discontinue use and replace it immediately.
To Next Page
Loading...
