xiii
D-I012.1109EN
innovators in agriculture
6.7.7 Define Feed Groups 6-11
6.7.8 Define the Push Power for a Feed Group 6-12
6.7.9 Set a Time Path 6-12
6.7.10 Make or Restore a Backup 6-13
6.8 Start or Stop Timed Actions 6-13
6.9 Start, Stop or Pause a Manual Route 6-14
6.10 Block a Route 6-15
6.11 Reset the Emergency Stop Button 6-15
7. Maintenance 7-1
7.1 Introduction 7-1
7.2 Preventive Maintenance Schedule 7-1
7.3 Preparation 7-2
7.3.1 Break or close the Power Circuit 7-2
7.3.2 Remove or Install the Cover 7-2
7.3.3 Switch OFF or ON the JUNO 150 7-3
7.4 Maintenance Procedures 7-4
7.4.1 Clean the Charging Strips and the Charging Electrodes 7-4
7.4.2 Replace the Rubber Skirt 7-5
7.4.3 Tighten a Chain 7-6
8. Test and Adjustment 8-1
8.1 Introduction 8-1
8.2 Settings 8-1
8.2.1 Set the Real-Time Clock 8-1
8.2.2 Set the Display Language 8-1
8.2.3 Modify the Beep Frequency for a Route 8-1
8.2.4 Modify the Beep Length 8-2
8.2.5 Modify the Feed Push Power 8-2
8.3 Tests 8-2
8.3.1 Analyse the Reliability of a Route 8-2
8.3.2 Test a Route 8-3
8.3.3 Make sure the Battery is Loaded 8-3
8.3.4 Make sure the Battery is Charging 8-3
8.3.5 Test the Ultrasonic Sensor 8-4
9. Troubleshooting 9-1
9.1 Introduction 9-1
9.2 Alarms and Reports 9-1
9.2.1 Recover Alarms 9-1
9.2.2 Alarm List 9-2
9.2.3 Read a Report 9-8
9.2.4 Report List 9-8
9.2.5 Information Report List 9-10
9.3 Troubleshooting Tables 9-11
9.3.1 Troubleshooting Table JUNO 150 Vehicle 9-11
9.3.2 Troubleshooting Table JUNO 150 Charging Station 9-13
To Next Page
Loading...
