Theservercomeswithtwo92mmx38mmhot-swapfansinthefancageassembly.Thefollowing
instructionscanbeusedtoinstallanyhot-swapfanintheserver.
Notes:
1.
Figure145.Theavailablefansocketsintheserver
2.Youcanorderthetwoadditionalfansforredundantcooling.
Attention:Staticelectricitythatisreleasedtointernalservercomponentswhentheserverispowered-on
mightcausetheservertohalt,whichmightresultinthelossofdata.Toavoidthispotentialproblem,
alwaysuseanelectrostatic-dischargewriststraporothergroundingsystemwhenyouworkinsidethe
serverwiththepoweron.
Readthesafetyinformationin“Safety”onpagevand“Installationguidelines”onpage29.
Ifyouarereplacingaservercomponentintheserver,youneedtoturnofftheserverandperipheraldevices,
anddisconnectthepowercordsandallexternalcables.
Toremoveahot-swapfan,completethefollowingsteps.
Step1.Carefullyturntheserveronitssidesothatitislyingflat,withthecoverfacingup.
Step2.Unlockandremovetheleft-sidecover(see“Removingtheleft-sidecover”onpage182).
Step3.Openthefanlockingandpullitupfromthefancageassembly.
Chapter6.Removingandreplacingcomponents225
To Next Page
Loading...
