To install the top cover, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Figure 66. Top cover installation
Step 1. Ensure that the cover latch is in the open position. Lower the top cover onto the chassis until both
sides of the top cover engage with the guides on both sides of the chassis. Then, slide the top
cover to the front of the chassis.
Note: Before you slide the top cover forward, ensure that all the tabs on the top cover engage the
chassis correctly.
Step 2. Pivot the cover latch until the top cover snaps into position. Ensure that the cover latch is
completely closed.
Step 3. Use a screwdriver to turn the cover lock to the locked position.
After installing the top cover, complete the parts replacement. See “Complete the parts replacement” on
page 203.
Air baffle replacement
Use this information to remove and install the air baffle.
S033
Chapter 3. Hardware replacement procedures 91
To Next Page