4. Disconnect the fan board power cable.
5. Disconnect any cables that might impede your access to the fan board. Before cable disconnection,
record where the cables are connected to the system board.
To remove the fan board, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Figure 174. Fan board removal
Step 1. Remove the five screws from the fan board.
Step 2. Gently hold and lift the fan board from the system board tray.
If you are instructed to return the old fan board, follow all packaging instructions and use any packaging
materials that are provided.
Install the fan board
Use this information to install the fan board.
“Read the
installation
Guidelines” on
page 79
“Power off
the server for
this task” on
page 11
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
Before installing the fan board, touch the static-protective package that contains the new fan board to any
unpainted surface on the outside of the server. Then, take the new fan board out of the package and place it
on a static-protective surface.
To install the fan board, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
190 ThinkSystem SR635 Maintenance Manual
To Next Page
Loading...
