Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Figure 151. Super capacitor module removal
Step 1. Open the retention clip on the holder of the super capacitor module.
Step 2. Take the super capacitor module out of the holder.
Install a super capacitor module on the M.2/riser support bracket
Use this information to install a super capacitor module.
“Read the
installation
Guidelines” on
page 79
“Power off
the server for
this task” on
page 11
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
Before installing the RAID super capacitor module on the chassis, touch the static-protective package that
contains the new RAID super capacitor module to any unpainted surface on the outside of the server. Then,
take the new RAID super capacitor module out of the package and place it on a static-protective surface.
To install a super capacitor module, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Step 1. Open the retention clip on a holder, put a super capacitor module into the holder, and press it down
to secure it into the holder.
Figure 152. Super capacitor module installation
168 ThinkSystem SR635 Maintenance Manual
To Next Page
Loading...
