EasyManua.ls Logo

Lenovo ThinkSystem SR635 - Install the OCP 3.0 Ethernet Adapter

Lenovo ThinkSystem SR635
246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before removing the OCP 3.0 Ethernet adapter, touch the static-protective package that contains the new
OCP 3.0 Ethernet adapter to any unpainted surface on the outside of the server. Then, take the new OCP 3.0
Ethernet adapter out of the package and place it on a static-protective surface.
To remove the OCP 3.0 Ethernet adapter, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
Youku: http://list.youku.com/albumlist/show/id_52222446.html
Step 1. Loosen the thumbscrew that secures the adapter. Pull out the OCP 3.0 Ethernet adapter as shown.
Figure 89. OCP 3.0 Ethernet adapter removal
Install the OCP 3.0 Ethernet adapter
Use this information to install the OCP 3.0 Ethernet adapter.
Read the
installation
Guidelines” on
page 79
Power off
the server for
this task” on
page 11
ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Note: If there is an OCP 3.0 Ethernet adapter installed, when the system is powered off but still plugged in to
AC power, system fans will continue to spin at a much lower speed. This is the system design to provide
proper cooling for the OCP 3.0 Ethernet adapter.
Before installing the OCP 3.0 Ethernet adapter, touch the static-protective package that contains the new
OCP 3.0 Ethernet adapter to any unpainted surface on the outside of the server. Then, take the new OCP 3.0
Ethernet adapter out of the package and place it on a static-protective surface.
To install the OCP 3.0 Ethernet adapter, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
114 ThinkSystem SR635 Maintenance Manual

Table of Contents

Related product manuals