Figure 86. Hot-swap drive removal
After removing a hot-swap drive:
1. Install the drive filler or a new drive to cover the drive bay. See “Install a hot-swap drive” on page 112.
2. If you are instructed to return the old hot-swap drive, follow all packaging instructions and use any
packaging materials that are provided.
Install a hot-swap drive
Use this information to install a hot-swap drive.
“Read the
installation
Guidelines” on
page 79
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
Before installing a hot-swap drive:
1. Remove the drive filler from the drive bay. Keep the drive filler in a safe place.
Figure 87. Drive filler removal
2. Touch the static-protective package that contains the new drive to any unpainted surface on the outside
of the server. Then, take the new drive out of the package and place it on a static-protective surface.
3. See “Technical rules for drives” on page 87 before you install the hot-swap drive.
112
ThinkSystem SR635 Maintenance Manual
To Next Page
Loading...
