To install the TPM adapter, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Step 1. Locate the TPM connector on the system board.
Step 2. Insert the TPM adapter into the TPM connector on the system board.
Notes:
• Carefully handle the TPM adapter by its edges.
• Your TPM adapter might look slightly different from the illustration.
Figure 125. TPM adapter installation
After installing the TPM adapter, complete the parts replacement. See “Complete the parts replacement” on
page 203.
Rear hot-swap drive cage replacement
Use this information to remove and install the rear hot-swap drive cage.
Note: The term “hot-swap drive” refers to all the supported types of 2.5-inch hot-swap hard disk drives and
hot-swap solid-state drives.
Chapter 3. Hardware replacement procedures 147
To Next Page
Loading...
