Figure 108. Intrusion switch removal
If you are instructed to return the old intrusion switch, follow all packaging instructions and use any
packaging materials that are provided.
Install an intrusion switch
Use this information to install an intrusion switch.
“Read the
installation
Guidelines” on
page 79
“Power off
the server for
this task” on
page 11
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
Before installing the intrusion switch, touch the static-protective package that contains the new intrusion
switch to any unpainted surface on the outside of the server. Then, take the new intrusion switch out of the
package and place them on a static-protective surface.
To install an intrusion switch, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Note: The intrusion switch can only be installed in riser 1 assembly (LP/FHFL). The riser bracket in which the
intrusion switch is installed might be different from the illustration below, but the installation method is the
same. For different types of supported riser bracket, see Figure 105 “Riser 1 assembly (LP/FHFL) installation”
on page 126.
Step 1. Insert the intrusion switch into the riser bracket and push it in the direction as shown until it is fully
seated.
Chapter 3. Hardware replacement procedures 129
To Next Page
Loading...
