Figure 176. PIB board removal
Step 1. Remove the five screws from the PIB board.
Step 2. Gently hold and lift the PIB board from the system board tray.
If you are instructed to return the old PIB board, follow all packaging instructions and use any packaging
materials that are provided.
Install the PIB board
Use this information to install the PIB board.
“Read the
installation
Guidelines” on
page 79
“Power off
the server for
this task” on
page 11
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
Before installing the PIB board, touch the static-protective package that contains the new PIB board to any
unpainted surface on the outside of the server. Then, take the new PIB board out of the package and place it
on a static-protective surface.
To install the PIB board, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
192 ThinkSystem SR635 Maintenance Manual
To Next Page
Loading...
