System board jumpers
The following illustration shows the location of the jumpers on the system board of your server.
Important:
• Before you move any jumpers, turn off the server; then, disconnect all power cords and external cables.
Do not open your server or attempt any repair before reading and understanding the following information:
–
http://thinksystem.lenovofiles.com/help/topic/safety_documentation/pdf_files.html
– “Handling static-sensitive devices” on page 82
• Any system-board switch or jumper block that is not shown in the illustrations in this document are
reserved.
Figure 17. System board jumpers
26 ThinkSystem SR635 Maintenance Manual
To Next Page
Loading...
