Install a PCIe adapter
Use this information to install a PCIe adapter.
“Read the
installation
Guidelines” on
page 79
“Power off
the server for
this task” on
page 11
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
Before installing a PCIe adapter:
1. Touch the static-protective package that contains the new PCIe adapter to any unpainted surface on the
outside of the server. Then, take the new PCIe adapter out of the package and place it on a static-
protective surface.
2. Locate the correct PCIe slot for the PCIe adapter. For information about the PCIe slots and supported
PCIe adapters, see “Rear view” on page 16.
3. Before installing the PCIe adapter, refer to the specific technical rules for the PCIe adapter:
• “Technical rules for HBA/RAID adapters” on page 88
• “Technical rules for PCIe NVMe adapter” on page 88
• “Technical rules for Ethernet adapters” on page 88
4. If the server is installed with 280-watt processor, see “Rules about 280-watt processor installation” on
page 82 for PCIe adapter installation limitations.
To install a PCIe adapter, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Note: The internal riser card supports only a RAID/HBA 8i adapter, not supporting a RAID/HBA 16i or 24i
adapter.
Step 1. Align the PCIe adapter with the PCIe slot on the riser card. Then, carefully press the PCIe adapter
straight into the slot until it is securely seated and its bracket also is secured.
Step 2. Pivot the latch on the riser bracket to the closed position.
Chapter 3. Hardware replacement procedures 125
To Next Page
Loading...
