• Heat sink and processor
• Memory modules
• M.2 adapter
• Riser assemblies
• Rear hot-swap drive cage
• RAID super capacitor module
• CMOS battery
• Middle drive cage
3. Update the VPD. See “Update the Vital Product Data (VPD)” on page 197.
• (Required) Machine type
• (Required) Serial number
• (Optional) Asset tag
• (Optional) UUID
4. Configure the security settings. See “Configure security settings” on page 199.
• (Required) Assert Physical Presence
• (Required) Set the TPM policy
• (Required) Lock the TPM policy
• (Optional) Toggle the TPM version
• (Optional) Enable UEFI secure boot
Update the Vital Product Data (VPD)
Use this topic to update the Vital Product Data (VPD).
VPD to be updated after system board replacement:
• (Required) Machine type
• (Required) Serial number
• (Optional) Asset tag
• (Optional) UUID
Recommended tools:
• Lenovo XClarity Provisioning Manager Lite V2
• Lenovo XClarity Essentials OneCLI commands
Using Lenovo XClarity Provisioning Manager Lite V2
Steps:
1. Start the server and press F11. The Lenovo XClarity Provisioning Manager Lite V2 interface is displayed
by default.
2. Choose System Summary. The “System Summary” tab page is displayed.
3. Click Update VPD, then, follow on-screen instructions to update the VPD.
Using Lenovo XClarity Essentials OneCLI commands
• Updating machine type
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model> [access_method]
Chapter 3. Hardware replacement procedures 197
To Next Page
Loading...
