Figure 132. Rear hot-swap drive cage installation
Step 6. Connect the signal cable and connect the power cable to the system board. See “Internal cable
routing” on page 27.
After installing the rear hot-swap drive cage:
1. Reinstall the drives or drive fillers into the rear hot-swap drive cage. See “Install a hot-swap drive” on
page 112.
2. Complete the parts replacement. See “Complete the parts replacement” on page 203.
Middle drive cage replacement
Use this information to remove and install the middle drive cage.
Remove the middle drive cage
Use this information to remove the middle drive cage.
“Read the
installation
Guidelines” on
page 79
“Power off
the server for
this task” on
page 11
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
Before removing the middle drive cage:
1. Remove the top cover. See “Remove the top cover” on page 89.
2. Disconnect the cables from the backplane.
To remove the middle drive cage, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
152
ThinkSystem SR635 Maintenance Manual
To Next Page
Loading...
