“Read the
installation
Guidelines” on
page 79
“Power off
the server for
this task” on
page 11
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
Before installing the backplane:
1. Touch the static-protective package that contains the new backplane to any unpainted surface on the
outside of the server. Then, take the new backplane out of the package and place it on a static-
protective surface.
2. Connect the cables to the backplane. See “Server model with eight 2.5-inch SAS/SATA drives” on page
39.
To install the backplane, complete the following steps:
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Figure 113. Installation of backplane for eight 2.5-inch hot-swap drives
Step 1. Align the two pins on the backplane with the corresponding holes in the chassis.
Step 2. Lower the backplane into the chassis. Ensure that the pins pass through the holes and the
backplane is fully seated in place.
After installing the backplane:
1. Reinstall all the drives and drive fillers into the drive bays. See “Install a hot-swap drive” on page 112.
2. Complete the parts replacement. See “Complete the parts replacement” on page 203.
Remove the backplane for ten 2.5-inch hot-swap drives
Use this information to remove the backplane for ten 2.5-inch hot-swap drives.
Chapter 3. Hardware replacement procedures 135
To Next Page
Loading...
