Remove the rear hot-swap drive cage
Use this information to remove the rear hot-swap drive cage.
“Read the
installation
Guidelines” on
page 79
“Power off
the server for
this task” on
page 11
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
Before removing the rear hot-swap drive cage:
1. Remove the top cover. See “Remove the top cover” on page 89.
2. Remove the drives or drive fillers installed in the rear hot-swap drive cage. See “Remove a hot-swap
drive” on page 111 and “Install a hot-swap drive” on page 112.
3. Disconnect the rear hot-swap drive cage cables from the system board or the PCIe adapter.
To remove the rear hot-swap drive cage, complete the following step:
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Figure 126. Rear hot-swap drive cage removal
Step 1. Hold the two blue touch points and directly lift the rear hot-swap drive cage out of the chassis.
Step 2. If the rear backplane is reused, remove the rear backplane. See “Remove the rear backplane” on
page 138.
If you are instructed to return the old rear hot-swap drive cage, follow all packaging instructions and use any
packaging materials that are provided.
Install the rear hot-swap drive cage
Use this information to install the rear hot-swap drive cage.
148 ThinkSystem SR635 Maintenance Manual
To Next Page
Loading...
