• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Step 1. Attach the OCP 3.0 Ethernet adapter label that comes with this option on the rear of the server.
Figure 90. OCP 3.0 Ethernet adapter label installation
Step 2. Push the OCP 3.0 Ethernet adapter as shown to insert it into the connector on the system board.
Tighten the thumbscrew to secure the adapter.
Figure 91. OCP 3.0 Ethernet adapter installation
After installing the OCP 3.0 Ethernet adapter, complete the parts replacement. See “Complete the parts
replacement” on page 203.
Internal riser assembly replacement
Use this information to remove and install the internal riser assembly.
Remove the internal riser assembly
Use this information to remove the internal riser assembly.
“Read the
installation
Guidelines” on
page 79
“Power off
the server for
this task” on
page 11
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
Chapter 3. Hardware replacement procedures 115
To Next Page
Loading...
