Note: The riser assembly you want to remove might be different from the following illustrations, but the
removal method is the same.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Step 1. If there is any PCIe adapter installed on the riser card, record the cable connections first. Then,
disconnect all cables from the PCIe adapter.
Step 2. For riser 1 assembly (LP/FHFL), if there is an intrusion switch installed on it, disconnect the cable of
the intrusion switch from the system board.
Step 3. Grasp the riser assembly by its edges and carefully lift it out of the chassis.
Figure 97. Riser assembly removal
Step 4. If necessary, remove the PCIe adapters that are installed on the riser card. See “Remove a PCIe
adapter” on page 122.
Step 5. If necessary, remove the intrusion switch that is installed on the riser bracket. See “Remove an
intrusion switch” on page 128.
Step 6. Remove the two screws that secure the riser card to the bracket. Then, remove the riser card.
Figure 98. Riser card removal
Chapter 3. Hardware replacement procedures 119
To Next Page
Loading...
