Figure 182. Disassembling the system board
Step 1. Remove the following screws as illustrated:
• 13 slotted screws (with PH2 screwdriver)
• One round standoff (with 0.5 mm flathead screwdriver)
• One guiding pin standoff (with 6 mm wrench)
• One plunger (with 11 mm and 16 mm wrench)
• Four T20 screws on the CPU socket (with T20 screwdriver)
• Four hexagon bolts on VGA and COM (RS232) connectors (with 5 mm wrench)
Step 2. Separate the components
1 2 3 4 5 6 7 from the system board.
After disassembling the system board, comply with local regulations when recycling.
224
ThinkSystem SR635 Maintenance Manual
To Next Page
Loading...
