1 PCIe slot 1 on riser 1 assembly
Your server supports the following riser card for riser 1 assembly:
Slot 1: PCIe x16 (x16, x8, x4, x1), full-height, full-length
2 PCIe slot 3 on riser 2 assembly
Your server supports the following riser card for riser 2 assembly:
Slot 3: PCIe x16 (x16, x8, x4, x1), low-profile
Rear view of server model with two hot-swap drive bays and one PCIe slot
The following illustration shows the rear view of the server model with two hot-swap drive bays and one PCIe
slot. Depending on the model, your server might look slightly different from the illustration below.
Figure 11. Rear view of server model with two hot-swap drive bays and one PCIe slot
Table 8. Components on the rear of the server
1 PCIe slot 1
2 Rear 2.5-inch drive bays
3 Power supply 1
4 Power supply 2 (optional)
5 NMI button
6 Serial port
7 USB 3.2 Gen 1 (5 Gbps) connectors 8 VGA connector
9 BMC management network connector 10 Ethernet connectors on OCP 3.0 Ethernet adapter
(optional, two or four connectors may be available)
1 PCIe slot 1
Slot 1: PCIe x16 (x16, x8, x4, x1), low-profile
2 Rear 2.5-inch drive bays
Used to install two 2.5-inch hot-swap drives on the rear of the server.
The number of the installed drives in your server varies by model. When you install drives, follow the order of
the drive bay numbers.
The EMI integrity and cooling of the server are protected by having all drive bays occupied. The vacant drive
bays must be occupied by drive bay fillers or drive fillers.
Rear view of server model with one PCIe slot
The following illustration shows the rear view of the server model with one PCIe slot. Depending on the
model, your server might look slightly different from the illustration below.
18
ThinkSystem SR635 Maintenance Manual
To Next Page
Loading...
