Four 3.5-inch SATA drives and rear SAS/SATA drive assembly
Notes:
• When the SAS/SATA backplanes are connected to PCIe connectors on the system board, only SATA
drives are supported. No SAS drives are supported.
• The cable routing illustration is based on the scenario that the rear hot-swap drive cage is installed.
Depending on the model, the rear hot-swap drive cage might not be available on your server.
Figure 24. Cable routing for server model with four 3.5-inch SATA drives and rear SAS/SATA drive assembly
Cable
From To
1 SAS signal cable for front
backplane
SAS connector on the front
backplane
PCIe connector 6 on the system
board
34 ThinkSystem SR635 Maintenance Manual
To Next Page
Loading...
