Eight 2.5-inch SATA drives and rear NVMe drive assembly
Notes:
• When the SAS/SATA backplanes are connected to PCIe connectors on the system board, only SATA
drives are supported. No SAS drives are supported.
• The cable routing illustration is based on the scenario that the rear hot-swap drive cage is installed.
Depending on the model, the rear hot-swap drive cage might not be available on your server.
Figure 36. Cable routing for server model with eight 2.5-inch SATA drives and rear NVMe drive assembly
Cable
From To
1 SAS signal cable for front
backplane
SAS 0 and SAS 1 connectors on
the front backplane
PCIe connector 6 on the system board
2 NVMe signal cable for rear
backplane
NVMe connectors on the rear
backplane
PCIe connector 1 on the system board
Chapter 2. Server components 45
To Next Page
Loading...
