Commissioning
Commissioning via the diagnosis terminal
6
l
137
EDS84DG752 EN 7.0
6.4 Commissioning via the diagnosis terminal
The X400 diagnosis terminal serves to quickly and easily set parameters and display
current actual values and device states by means of the corresponding display parameters.
For this purpose, the diagnosis terminal must be plugged onto the X70 diagnostic interface
on the top of the device.
} Danger!
Uncontrolled motor movement possible
In general, changing a parameter causes an immediate response in the
inverter.
Possible consequences:
ƒ This may lead to undesirable behaviour on the motor shaft if the inverter
has been enabled.
Protective measures:
ƒ Make changes in small steps and wait for response.
ƒ Certain device commands or settings which may cause critical states of drive
behaviour constitute exceptions. Such parameter changes are only possible
if the inverter is inhibited. Otherwise, a corresponding error message will be
issued.
) Note!
Plugging and unplugging the diagnosis terminal during operation is
permissible.
, More information ....
Detailed information regarding the diagnosis terminal can be found in the
operating instructions for the X400 keypad & diagnosis terminal.
To Next Page
Loading...
