Lenze 8400 motec - Settings at the Drive Unit; Mounting of the Drive Unit

Installation
Retrofitting the 8400 motec controller
Settings at the Drive Unit
5
l
85
EDS84DG752 EN 7.0
5.5.5 Settings at the Drive Unit
Besides parameter setting of the DU via diagnosis terminal (keypad with cable connection)
or parameter setting using the »Engineer«, some features can be set directly (¶ 125).
5.5.6 Mounting of the Drive Unit
0.37 ... 3 kW
If all previous steps have been executed and completed, the DU can be mounted.
How to proceed:
1. Position the DU in parallel to the WU and CU without twisting it. The four fixing
screws show the correct position if they are put through the locating holes of the CU
into the threads of the WU.
2. The connectors are contacted with light pressure and the DU has reached the final
position.
3. Tighten the four fixing screws (5.0 Nm/44 lb−in)
The installation is completed.
4 ... 7.5 kW
The DU has already been mounted with the WU and is completed by attaching the cover
to the CU.