Lenze 8400 motec - SET Mode

Commissioning
Commissioning via the diagnosis terminal
SET mode
6
l
144
EDS84DG752 EN 7.0
6.4.5 SET mode
In SET mode, the inverter is controlled via the diagnosis terminal. You can change the speed
setpoint and enable or inhibit the inverter (RFR/run). Other setpoint sources are ignored.
ƒ Activate SET mode: press "DISP" softkey button and confirm with "OK" softkey
button.
ƒ Exit SET mode: press "DISP" softkey button and confirm with "OK" softkey button.
) Note!
SET mode can only be activated in the "OperationEnabled" device state
(controller inhibit is deactivated, green LED on the inverter is lit permanently).
ƒ Controller inhibit is only indicated in the keypad. The cause of controller
inhibit is shown in detail in C00158 (¶ 8400motec reference manual).