Commissioning
Handling the memory module
6
l
123
EDS84DG752 EN 7.0
6.2 Handling the memory module
} Danger!
After power−off, wait at least three minutes before working on the inverter.
When removing the memory module, ensure that the inverter is deenergised.
All parameters of the drive system are saved non−volatilely on the memory module. These
include the parameters of the inverter and communication−relevant parameters for the
communication unit used.
The plug−in version is especially suited for
ƒ restoring an application after replacing a device,
ƒ duplicating identical drive tasks within the 8400 motec frequency inverter series,
e.g. by using the EPM Programmer that is optionally available.
0.37...3kW
E84DG128
To Next Page
Loading...
