LevelOne WGR-8031 - Load Settings from File

LevelOne WGR-8031

331 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

287

Load Settings from File

It allows you to reload the settings from the file which was saved

previously.

1. From the left-hand Management menu, click on Reset

factory default. The following page is displayed:

Figure 12: Reset to Defaults page

2. Click on Browse….to browse to where the config.dat is.

Table of Contents

Default Chapter1
- User Manual1
- Table of Contents2
1 Introduction9
- Features9
- Device Requirements9
- Using this Document10
- Getting Support10
2 Getting to Know the Device11
- Computer / System Requirements11
- Package Contents11
- LED Meanings & Activations12
  - Front Panel12
  - Rear and Right Panel and Bottom Side12
- Computer Configurations under Different OS, to Obtain IP Address Automatically14
4 Connecting Your Device38
- Connecting the Hardware38
5 Utility CD Execution40
- Connecting the Hardware40
- WAN Interface Setup41
- Wireless Configuration - 5Ghz45
- Wireless Configuration - 2.4Ghz46
- Wireless Connection47
6 What the Internet/Wan Access of Your Own Network Now Is49
- Internet/Wan Access Is the DHCP Client51
- Internet/Wan Access Is the Static IP52
- Internet/Wan Access Is the Pppoe Client54
7 Getting Started with the Web Pages55
- Accessing the Web Pages55
- Testing Your Setup58
- Default Device Settings58
8 Quick Setup60
- Operation Mode Setup61
- WAN Interface Setup64
- Wireless 5Ghz Basic Settings68
- Wireless 5Ghz Security Setup73
- Wireless 2.4Ghz Basic Settings78
- Wireless 2.4Ghz Security Setup83
9 Operation Mode90
- Setting Operation Mode90
10 Wireless Network - Wlan1(5Ghz)91
- Basic Settings91
- Advanced Settings93
- Security94
- Access Control101
  - Allow Listed102
  - Deny Listed103
- WDS Settings104
  - Configure WDS (Wireless Distribution System) Only105
  - Configure AP (Access Point) + WDS (Wireless Distribution System)109
- Site Survey114
  - Configure Wireless ISP + Wireless Client + Site Survey115
- Wps120
- Operations of AP - AP Being an Enrollee125
- Operations of AP - AP Being a Registrar138
  - AP Mode138
  - Push Button Method142
- Wireless Schedule146
11 Wireless Network - Wlan2(2.4Ghz)147
- Basic Settings147
- Advanced Settings150
- Security151
- Access Control157
  - Allow Listed158
  - Deny Listed159
- WDS Settings160
  - Configure WDS (Wireless Distribution System) Only161
  - Configure AP (Access Point) + WDS (Wireless Distribution System)167
- Site Survey172
  - Configure Wireless ISP + Wireless Client + Site Survey173
- Wps178
- Operations of AP - AP Being an Enrollee183
- Operations of AP - AP Being a Registrar196
  - AP Mode196
  - Push Button Method201
- Wireless Schedule205
12 LAN Interface206
- LAN Interface Setup206
- Changing the LAN IP Address and Subnet Mask208
- Show Client211
13 WAN Interface212
- Configuring Static IP Connection216
- Configuring DHCP Client Connection218
- Configuring Pppoe Connection220
- Configuring PPTP Connection222
- Configuring L2TP Connection226
- Clone MAC Address229
14 Ipv6232
- Ipv6 Wan Setting232
- Ipv6 Lan Setting233
- Radvd234
- Tunnel (6 over 4)236
15 Port Filtering237
- Port Filtering for TCP Port 80238
- Port Filtering for UDP Port 53240
16 IP Filtering242
- IP Filtering for TCP with Specified IP243
- IP Filtering for UDP with Specified IP245
- IP Filtering for both TCP and UDP with Specified IP246
17 MAC Filtering249
- MAC Filtering for Specified MAC Address250
18 Port Forwarding252
- Port Forwarding for TCP with Specified IP254
- Port Forwarding for UDP with Specified IP255
19 URL Filtering257
- URL Filtering for Specified URL Address258
20 Dmz260
- DMZ Host IP Address260
- 802.1Q Vlan262
21 802.1Q Vlan264
22 Route Setup264
23 Qos265
24 Status266
25 Statistics268
26 Dynamic DNS269
- Configure Dyndns271
- Configure TZO273
27 Time Zone Setting275
- SNTP Server and SNTP Client Configuration Settings275
28 Denial-Of-Service276
29 Tr-069 Config279
30 Log280
- System Log280
31 Firmware Update283
- About Firmware Versions283
- Manually Updating Firmware283
32 Save/Reload Settings285
- Save Settings to File285
- Load Settings from File287
- Resetting to Defaults289
33 Password291
- Setting Your Username and Password291
- Configuring Your Computers293
  - Configuring Ethernet Pcs293
- IP Addresses, Network Masks, and Subnets299
  - IP Addresses299
    - Structure of an IP Address299
    - Network Classes299
  - Subnet Masks300
- Upnp Control Point Software on Windows ME/XP302
  - Upnp Control Point Software on Windows ME302
  - Upnp Control Point Software on Windows XP with Firewall303
    - SSDP Requirements303
Troubleshooting306
- Troubleshooting Suggestions306
- Diagnosing Problem Using IP Utilities308
  - Ping308
  - Nslookup308
License Statement / Gpl Code Statement310

Other manuals for LevelOne WGR-8031

Quick Installation Guide28 pages

Related product manuals

Preview: LevelOne WBR-6802

LevelOne WBR-6802

Preview: LevelOne WBR-6013

LevelOne WBR-6013

Preview: LevelOne WAC-2000

LevelOne WAC-2000

LevelOne WAC-2003

Preview: LevelOne WBR-3405TX

LevelOne WBR-3405TX

Preview: LevelOne FSW-0511

LevelOne FSW-0511

Preview: LevelOne GEU-0822

LevelOne GEU-0822

Preview: LevelOne POI-3000

LevelOne POI-3000

Preview: LevelOne GSW-0507

LevelOne GSW-0507

Preview: LevelOne GSW-0807

LevelOne GSW-0807

Preview: LevelOne GBR-4001

LevelOne GBR-4001

Preview: LevelOne FSW-0508TX

LevelOne FSW-0508TX