LevelOne WGR-8031 - WAN Interface Setup; Static IP

64
WAN Interface Setup
This page is used to configure the parameters for Internet
network which connects to the WAN port of your Access Point.
Here you may change the access method to static IP, DHCP,
PPPoE, PPTP or L2TP by click the item value of WAN Access
type.
To change the WAN Access Type:
7. From the WAN Access Type drop-down list, select Static IP,
DHCP Client, PPPoE, PPTP, or L2TP setting determined
by your Network Administrator or ISP.
8. Click Next>>.
Static IP
In this mode, the device is supposed to connect to internet via
ADSL/Cable Modem. The NAT is enabled and PCs in four LAN
ports share the same IP to ISP through WAN port. The
connection type can be setup in WAN page by using static IP.
1. From the WAN Access Type drop-down list, select Static IP
setting determined by your Network Administrator or ISP.
2. Enter IP Address for example 172.1.1.1.
3. Enter Subnet Mask for example 255.255.255.0.
4. Enter Default Gateway for example 172.1.1.254.
5. Enter DNS for example 172.1.1.254.
6. Click Next>>.