2-78 Service Manual
7002-xxx
202 .54 Exit sensor may have
bounced. Fuser page
count stopped at
500,000 to preserve
data.
Exit sensor assembly. Go to “Fuser exit sensor
service check” on
page 2-138.
202 .55 Never sent the divert
command to the stacker.
Fuser page count more
than 500,000.
202 .56 Page is covering the exit
sensor during warm
up.Fuser page count
stopped at 500,000 to
preserve data.
Something is keeping the exit sensor in a
covered position. A page may not have
been cleared from a prior jam.
Check the fuser and area
around the fuser assembly for
any signs of debris or pieces of
paper or media.
202 .57 Timeout waiting for the
page ahead. Fuser page
count more than
500,000.
202 .58 Divert media command
issued too soon. Fuser
page count more than
500,000.
202 .59 Virtual page timed out
waiting for last page of
job to be safe in the
stapler accumulator.
Fuser page count more
than 500,000.
202 .90 Paper jam around the
exit or redrive area.
Fuser page count is not
available.
Page may be jammed in fuser exit or
redrive area.
• Make sure the redrive door
is complete closed.
• Check the fuser for any
signs of wear or
contamination. If any are
found, replace the fuser
assembly. See “Fuser
assembly removal” on
page 4-79.
• Turn media over to reduce
+W curl.
• Check upper redrive
diverter and diverter spring
for any signs of damage, a
loose spring, or binding
parts. Repair the redrive as
necessary.
• Check any installed output
options(s) that may be
installed for correct
installation and alignment.
• The fuser exit sensor may
not be functioning properly.
Go to “Fuser exit sensor
service check” on
page 2-138.
User attendance messages—paper jams and paper handling errors (2xx.xx)
Code
Sub
code
Description Possible causes Action
To Next Page
Loading...
