Diagnostic aids 3-35
7002-xxx
Key Repeat Initial Delay
When a key is touched repeatedly, this is the delay before the key begins repeating. The delay ranges from 0.25
seconds to 5 seconds. The default is 1 second. Values are given in increments of 0.25 seconds.
To change this setting:
1. Touch to select Key Repeat Initial Delay from the Configuration Menu.
2. Touch to increase the value or to decrease the value.
3. Touch Submit to save the change.
Touch Back to cancel and return to the Configuration Menu.
Key Repeat Rate
This is the number of times per second that a repeating key will repeat. The range is 1–100, with a default of 15
times per second.
To change this setting:
1. Touch to select Key Repeat Initial Delay from the Configuration Menu.
2. Touch to increase the value or to decrease the value.
3. Touch Submit to save the change.
Touch Back to cancel and return to the Configuration Menu.
Wiper Message
To change this setting:
1. Touch to select Wiper Message from the Configuration Menu.
2. Touch or to change the value. The values are On (default) and Off.
3. Touch Submit to save the change.
Touch Back to cancel and return to the Configuration Menu.
Exit Configuration Menu
Touch Exit Config Menu to exit the Diagnostics Menu and Resetting the Printer displays. The printer
performs a POR, and the printer returns to normal mode.
Exit
Config Menu
Exit
Config Menu
To Next Page
Loading...
