Repair information 4-47
7002-xxx
Lower exit guide assembly removal
Illustrations represent models X644e/X646e. Unless there is an indication, the procedure is the same. Differences
are shown side by side.
1. Remove the ADF front cover. See “ADF front cover removal” on page 4-6.
2. Remove the flatbed white cushion. See “Flatbed white cushion removal” on page 4-32.
3. Open the document cover.
4. Press the latch (A) to open the lower exit guide assembly.
5. Remove the two screws (B), and remove the metal plate (C). Set the plate aside.
6. Remove the screw (D) on the ADF frame.
7. Remove the lower exit guide assembly.
Installation note: Be sure to route the cable through the hole (E) in the front ADF frame.
A
B
C
E
D
To Next Page
Loading...
