Repair information 4-35
7002-xxx
Flatbed paper length sensor assembly removal
Illustrations represent models X644e/X646e. Unless there is an indication, the procedure is the same. Differences
are shown side by side.
1. Remove the scan cover (flatbed). See “Scan cover (flatbed) removal” on page 4-11.
2. Remove the flatbed contact glass. See “Flatbed contact glass removal” on page 4-31.
3. Remove the scanner right side cover. See “Lift the scan cover (flatbed). Scanner right side cover
removal” on page 4-12.
4. Remove the scanner left side cover. See “Scanner left side cover removal” on page 4-10.
5. Remove the three screws (A) that attach the hinge support bracket to the rear scan bracket.
A
To Next Page
Loading...
